It is one of the wood distressing techniques mentioned in this article. Start by giving it a light sand allover using 60 grit paper.
Step 1) the first coat.
How to distress furniture with chalk spray paint. You want this coat to be quite thick and our brushes hold lots of paint to help with that. Your cloth should be nice and wet but not too wet. Start it with light sanding until it reached your requirements.
Adding some slight distressing in appropriate places brings out depth and character to a piece. Once the product is dried completely apply first glaze of chalk paint and allow it to dry and within few hours apply the second layer of chalk paint and allow it dry for a couple of hours. Dust off sandy pieces, and you are done.
Sand and clean the piece. This technique works best for previously painted/stained dark wood. Then, gently rub any areas you want to distress.
On the second coat, you can angle the sprayer and get more into the details. Once you've finished covering all of the areas you want distressed, use your paintbrush to spread the topcoat over the entire piece. If you’re wanting a super chippy, primitive look, consider using milk paint instead of chalk paint (read more about the difference in those here ).
How long should chalk paint dry before distressing? Distress the furniture using sandpaper. 3) hammer a nail or screw into the table in small groupings to create a wormhole effect.
Just wipe over the distressed area several times with the fresh wipe. Allow enough time for the paint to dry thoroughly and, if necessary, apply a second coat. Apply wax and top layer of paint (optional) distress the piece with sandpaper and steel wool.
Here are some of the steps to distress the furniture product with chalk paint: Chalk paint, milk paint, latex paint and even acrylic craft paint can be distressed. Once dried, apply the second coating.
If you are after a chippy look, like the one pictured, just push a little harder. I find it’s best to get a fresh baby wipe and remove this film in order to showcase the original dark wood finish. Make sure that your first coat of paint is properly cured so that it won’t come off when you distress it.
Work small sections at a time, complete and move on to the next section. Once your paint is dry, take a fine or medium grit sandpaper and sand a few areas on your furniture that would naturally be distressed. If your paint starts to dry before you’re satisfied in that area, lightly mist the paint with your misting spray bottle and rework the section.
Spray back and forth, keeping the spraying steady and upright. Then i sprayed them with chalk paint and let them dry. All you have to do is use a piece of sandpaper or a sanding block to sand off the paint down to the wood on the high spots, edges or any.
Pick the color of the chalk paint, and with the use of chalk paintbrush, apply it to the furniture. Work the brush back and forth, without overlapping the paint, smooth even strokes. Using a lint free cloth ( this is the one i use ,) cover your finger with the cloth and dip it into water.
Once your base colour is dry, use a clean chalk paint® brush to apply the second. Go over the edges and corners. How do you paint furniture to look distressed?
2) bang with a hammer, specifically on the edges. But in case you are looking to give your piece a little more character, here’s some ideas that work wonders: Leave for 30 minutes to dry.
How to distress chalk spray paint distressing this paint is the best part! Spray a light coat on first, holding the sprayer straight. I love that with chalk paint you don’t have to wait a certain amount of time to recoat.
Apply one coat of paint to your piece; This technique works great for chalk based or mineral based paints! 1) sand with a high grit sandpaper to get circular grooves in the wood.
You can distress any kind of paint; This is called “wet distressing” because you used water to create the distressed look to your painted furniture. Start by laying down drop cloths and preparing the area.
Firstly clean the surface of that wood furniture product with clean water and dry cloth and allow it to dry in an open air. Last step is to apply a coat of neutral (clear) wax over the chalk finish to seal the paint. I have found that with latex paints the latex becomes rubbery and really does not wet distress well.
Here is how to distress furniture with spray paint and a sander to get that awesome vintage look. Then i used a paintbrush to brush off the bits of wax crumbs. Sand the surface of the piece.
Apply your base colour using a chalk paint® brush, moving the brush in every direction to create texture. First, i took a piece of candle wax and rubbed it in the places i wanted the base paint layer to show.